Mobile Aerial Work Platform

  • Employees may only operate machine if ‘Mobile Aerial Lift Training’ course has been taken.
  • Pre-Use Inspections – Inspect or Test the Following:
    • Operating and emergency controls
    • Safety devices and limit switches
    • Personal protective devices
    • Tires and wheels
  • Equipment structure
  • Air, hydraulic and fuel systems for leaks
  • Loose or missing parts
  • Cable and wiring harnesses
  • Placards, warning, control markings and operating manuals
  • Handrail systems including locking pins
  • Engine oil level
  • Battery fluid level
  • Coolant level
  • Propane bottle secured (if equipped)
  • Parking brake
  • Horn
  • Function Test:
    • Base functions and operation
    • Basket function and operation
    • Height / speed limiter switch (put machine in low speed when platform is raised)
    • Motion alarm
    • Hydraulic function test
    • Emergency controls
  • Work Area Inspection:
    • Manhole covers, grating or unstable surfaces
    • Ramps, inclines or rough surfaces.
    • Electrical hazards overhead
  • Underground utilities
  • Pedestrian / Vehicular traffic
  • Ground Condition
  • Use of Equipment:
    • Never modify or alter equipment unless approved by the manufacturer.
    • Never extend work platform with planks or other equipment.
    • Always wear fall restraint.
    • Fall restraint should be a 4’ lanyard.
    • Keep platform clean and free of tripping hazards.
    • Never operate equipment on incline.
    • Do not exceed equipment’s working load limit.
    • Make sure weight stays centered on platform.
    • Only use machine as it is intended.
    • Do not exceed side loading on platform.
  • Operating Procedures:
    • Perform pre-use safety inspections (see pre-use inspection) before each use. The aerial platform shall be given a visual inspection and functional test. If any problems are encountered, the aerial lift shall not be used and reported immediately to the Supervisor and Mechanic.
    • Do not exceed recommended weight capacity.
    • A workplace inspection shall be performed for any hazards such as manholes, roadway problems, slopes, overhead obstructions, wind and weather conditions, inadequate surface and support to withstand all load forces imposed by the aerial platform in all operating configurations and presence of unauthorized persons.
    • No one shall travel in a basket, platform or other elevated or aerial device that is moving on a roadway or worksite if road conditions, traffic, overhead wires, cables or other obstructions create danger to the operator or workers.
    • Ensure all required PPE is worn when operating aerial lift (see Info Sheet for Safety Belts, Lanyards and Lifelines).
    • Do not climb on outside of equipment.
    • Do not move the machine while platform is in an elevated position.